crwdns2933805:0crwdne2933805:0
crwdns2933797:0Lukas OKZ techniciancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Lukas OKZ technician
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Make four small (1 inch or smaller) balls of aluminum foil to support the PCB in the oven. |
|---|---|
| - | [* black] Line your baking sheet or dish with aluminium foil. |
| - | [* black] Place the 4 balls onto the baking sheet/dish |
| - | [* black] Place the graphics card onto the balls of foil, suspending the card so that no pressure is applied to any of the PCB components. |
| - | [* icon_caution] Ensure the side of the PCB with the heaviest components (usually the GPU) is on top so they don't drop off the board when the solder re-flows. |
| - | [* icon_note] If possible, push the corners of the PCB into the foil balls to keep everything in place. |
| + | [* black] Make some pieces of aluminum foil to cover capacitors |
| + | [* icon_note] start pre-aheating the oven - fan - 180C |
| + | [* black] Place the graphics card onto oven tray/ crate, making sure nothing seems unsafe. make sure capacitors are covered with aluminium foil |
| + | [* icon_note] provide generous dosage of "liquid FLUX" under chips |
| + | [* icon_note] turn oven to 210C (205C temperature at which solder melts) |