crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Sarahcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] After removing all the screws, carefully separate the cover of the phone with both hands pulling each side apart as if to open a book.
+[* black] After removing all the screws, carefully separate the two sides of the casing by pulling each side apart as if opening a book.
[* black] Carefully lay the sides of the phone so they are open side up.
-[* black] On the side of the phone with the logic board, locate the screw as indicated.
+[* red] On the side of the phone with the logic board, locate the screw as indicated.
[* black] Use the T-6 screwdriver to remove the screw from this part of the board.
- [* icon_note] Note: Take special care not to lose the white washer that is connected with the screw.
+ [* icon_note] Note: Take special care not to lose the white washer that seperates the screw from the logic board.