crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0KarlDcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Flip the device over and remove the two 4.5 mm Phillips screws on each side of the metal bracket (four screws in total).
+[* black] Be careful to apply a steady downward pressure on these screws so as not to strip them while turning.
[* black] Thread the display inverter, antenna, and display data cables through the bracket and remove the metal bracket.
+[* black] During reassembly, make sure that the wires are properly threaded through the hinge on the opposite sides of the screws. All three wires should have the shortest distance to travel before coming through the whole opposite of the screws.