crwdns2933803:01crwdne2933803:0
crwdns2933797:0Calvin Borncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Calvin Born
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Turn the snowboard base up on a stable flat surface so that your board does not move while you work on it. |
|---|---|
| + | [* black] Turn the snowboard over so the bottom of the board is facing up. |
| + | [* black] Set the snowboard down on a stable work surface so that it does not rock or move. |
| + | [* icon_note] We recommend using a table that is small enough to fit between the curves on either side of the board, or placing blocks of wood to raise the board from the table. |
| [* red] Assess the damage. If there are loose strands of material around the hole, slice them off carefully with a razor blade. | |
| [* black] Remove any extra wax with a metal scraper. | |
| - | [* black] |
| + | [* black] Use 150 grit sandpaper to roughen up the inside of the gouge. |