crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:015crwdne2933803:0

crwdns2933797:0Sam Goldheartcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_note] The LCD and Digitizer connectors are on the same cable assembly, so prying the end up should disconnect both connectors. Make sure the cables are fully disconnected before removing the display.
+[* icon_note] The LCD and Digitizer connectors are on the same cable assembly, so prying the end up should disconnect both connectors. Make sure the two cables are fully disconnected before removing the display.
[* black] Pry up on the end of the LCD/Digitizer cable to disconnect both connectors.
-[* icon_caution] When reassembling your phone, The LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.
+[* icon_reminder] When reassembling your phone, the LCD cable may pop off its connector. A blank screen, or white lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.