crwdns2933803:01crwdne2933803:0
crwdns2933797:0Nicolas Siemsencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nicolas Siemsen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] To remove your motor mounts you will need to raise, and support, your engine with a bottle jack. |
|---|---|
| + | [* black] Before you can do this you will need to remove the bolts that hold the engine to the mounts. This is done from below the car. |
| + | [* green] The bolts are allen head bolts; you will need an 8mm allen head socket. It should be a 1/2 inch drive socket as you will want a large wrench for leverage. These are often in very tightly. |
| + | [* red] The bolt on each mount is located up inside a recessed area as shown. |
| + | [* black] Remove the bolt and set it aside. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0