crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Sam Goldheartcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Goldheart

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Place the de-soldering wick on the solder joint and put the tip of the solder gun on it so the wick can heat up and absorb the old solder.
-[* black] Please remember that logic board components are very fragile and excessive heat can destroy these components.
-[* black] *IMPORTANT* When you bring the wick up from the logic board do it together with the solder gun ,failure to do so can cause the leftover solder to harden and solder the wick to the logic board and you could easily pull a logic board pad off.
+[* icon_caution] Please remember that logic board components are very fragile and excessive heat can destroy these components.
+[* icon_caution] ***Lift the wick and the solder gun up from the logic board at the same time.*** Failure to do so can cause the leftover solder to harden and solder the wick to the logic board and you could easily pull a logic board pad off.