crwdns2933803:018crwdne2933803:0
crwdns2933797:0Ralph Rileycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ralph Riley
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Microphones & connectors |
|---|---|
| + | [* red] Below the touch panel are FOUR microphones. Not one, not two… FOUR. |
| + | [* orange] Remove the adhesive (sigh) around the microphones with a flat-head screwdriver |
| + | [* black] Solvent may be used if the adhesive is too tough to remove. |
| + | [* green] Next, remove the flex connector through the slot. |
| + | [* black] This is the main flex connector that runs from the bottom to the top panel. |
| + | [* blue] This is another light guide for the LED that acts as the AXX 200’s Bluetooth indicator. |
| + | [* black] The actual LED is located on the touch panel PCB. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0