crwdns2933803:011crwdne2933803:0
crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove the four silver Phillips screws attaching the logic board to the outer case. |
|---|---|
| + | [* icon_caution] To remove the logic board, you must first de-solder the leads of both microphones from the logic board. When soldering on a circuit board, be sure not to heat up the connection excessively. |
| + | [* black] Use a pair of tweezers to gently pull each lead as you heat up the joint with the tip of a soldering iron. |
| + | [* icon_note] Repeat this process to remove all four microphone leads. Their locations are boxed in orange on the first picture. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0