crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Kimcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Kim

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Rotate the scanner so the screw hole is located on the top left hand side.
[* black] Place the spudger between the top casement and bottom casement of scanner with the hook facing up.
[* black] Gently pry the two casements apart beginning above the screw hole and working your way around.
-[* red] Note that on the two long sides, there is a tab 6 inches from either side connecting the top and bottom casement together. On the short sides of the scanner, there is a tab 2.3 inches in from the edges holding the top and bottom casement together.
+[* icon_caution] Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.