crwdns2933803:02crwdne2933803:0
crwdns2933797:0Nicolas Siemsencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nicolas Siemsen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] With the gauge removed from the body you can now carefully use a flat blade screw driver, or a small hook, to remove the black o-ring from the brass stem on the gauge. |
|---|---|
| + | [* black] Match the size of this o-ring with one from your kit. Likely, the new o-ring will have a slightly thicker "section" or thickness but should have the same inner diameter. The best one I found was a 2mm section, 4.4mm inner diamater o-ring. |
| + | [* black] Rub a small amount of synthetic, preferably silicone based grease on the o-ring. |
| + | [* black] Set aside the gauge until reassembly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0