crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tim Ellisoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tim Ellison
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Removing the metal backplate is simple. This is just stuck on with some flexible glue. So prise something under and off it pops. |
|---|---|
| + | [* black] Inside you can see a number of large cut outs in the rear of the plastic casing. |
| + | [* red] Note the small pinhole in the metal backplate that aligns with the rubber sealed hole in the plastic casing - more on that later. |
| + | [* yellow] There is also a very small ground out area inside the metal backplate that appears to align with the rotating mass of the vibrator. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0