crwdns2933803:09crwdne2933803:0
crwdns2933797:0midiman127crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 midiman127
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place circuit board back into the casing and attach all screws. |
|---|---|
| + | [* black] If positioned correctly the rubber band will make connection between the new LCD and the board. |
| + | [* black] Push the wires back between the side casing and the circuit board. The order is now reversed: 1st Black, 2nd Orange, 3rd White. |
| + | [* black] Re-attach all connectors onto the circuit board except the flash base. |
| + | [* black] Insert batteries and hold the cap closed with your fingers. It will not snap closed until the casing is back together. |
| + | [* black] Turn on the flash and check if the LCD works. Push the back-light button (above Pilot) to make sure it works. |
| + | [* black] After the test remove batteries. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0