crwdns2933803:07crwdne2933803:0
crwdns2933797:0midiman127crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 midiman127
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Remove 5 screws holding the circuit board. |
|---|---|
| + | [* black] Remove screw holding metal tab. The screw is different than other 5. Make sure you leave it in the tab. |
| + | [* black] Remove screw holding plastic cap. Keep screw in the cap as it is a different size. |
| + | [* black] Take the circuit board out of the casing flipping it over. |
| + | [* black] There is a clear plastic plate (red) between the LCD and the circuit board. It might fall out. It is used to distribute the back-light. |
| + | [* black] Pull the old LCD off carefully. Make sure not to tear the rubber band (green). This is used to transfer the signals from the board to the LCD. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0