crwdns2933803:06crwdne2933803:0
crwdns2933797:0Spencer Penningtoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Pennington
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Insert Stud Die into Snap Press |
|---|---|
| - | [* black] Insert the stud die into the upper fitting of the hand press: |
| - | [* black] Unscrew the tightening mechanism on the side of the press near the die fitting (reference red arrow, image #1) |
| - | [* black] Insert the die upward and hold it in place |
| - | [* black] Re-secure the tightening mechanism |
| - | [* icon_note] Depending on the screw holding the tightening mechanism in place, a tool (such as a screwdriver or hex key) may be needed instead of using fingers |
| + | [title] Insert the stud die into the hand press |
| + | [* red] Using your fingers, a screwdriver, or a hex key, as needed, unscrew the tightening mechanism on the side of the press near the die fitting. |
| + | [* black] Insert the die upward and hold it in place. |
| + | [* black] Tighten the tightening mechanism. |