crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Amos Hinecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Amos Hine

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the two 3.4mm screws that hold down the rearward edge of the card with a Phillips PH0 screwdriver.
- [* icon_note] The card is spring loaded at the receptacle, so unless you hold it down, it will spring up once the last screw is removed.
-[* black] Allow the card to lift itself up, and then simply slide it out of the black receptacle.
+[* red] Remove the two 3.4mm screws that hold down the right edge of the card with a Phillips PH0 screwdriver.
+ [* icon_note] The card is spring loaded at the receptacle. Unless you hold it down, the card will spring up once both screws are removed.
+[* black] Allow the card to lift up, and then slide it out of the black receptacle.
[* icon_reminder] When putting the card back in, make sure it is fully seated in the receptacle before pushing it down to re-insert the screws.