crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Griffin Paulcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Griffin Paul

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Starting at the wide base of the triangular sections, use the 10 mm nuts and bolts to attach two solar panel plates together. First hand tighten each bolt/nut pair, then secure them with your two 10 mm wrenches.
-[* red] On the way to the center, DO NOT install a nut and bolt in the ***THIRD TO LAST*** drill hole. This is where you will attach the Pipe Ring Brackets later on.
+[* red] On the way to the center, DO NOT install a nut and bolt in the ***THIRD TO LAST*** hole. This is where the Pipe Ring Bracket is attached later on.