crwdns2933423:0crwdne2933423:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Mykhaylo Hruzdyevcrwdnd2933797:0crwdne2933797:0

crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Jeff Suovanen

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* icon_caution] Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly.
-[* black] Slowly pull one of the battery adhesive strips away from the battery, toward the bottom of the iPhone. Pull the white portion of the strip when possible, the black tab may fall off.
-[* black] Pull steadily, maintaining constant tension on the strip as it slips out from between the battery and the rear case. For best results, pull the strip at a 60º angle or less.
-[* black] Be careful not to snag it on any of the other internal iPhone components.
-[* icon_note] The strip will stretch to many times its original length. Continue pulling, re-grabbing the strip near the battery if necessary, until the entire strip comes free.
+[* icon_caution] Постарайтесь, чтобы полоски были плоскими и не скручивались во время этой процедуры; скрученные полоски будут склеиваться и ломаться, вместо того, чтобы вытаскивать их чисто.
+[* black] Медленно тяните одну из клейких полосок из-под батареи, в направлении нижней части iPhone. По возможности тяните за белую часть полоски, так как черная часть может оторваться.
+[* black] Постоянно подтягивайте, поддерживая постоянное натяжение полосы, пока она не выскользнет из-под батареи. Для достижения наилучших результатов потяните полосу под углом 60º или менее.
+[* black] Будьте осторожны, чтобы не зацепить ею ни на одном из других внутренних компонентов iPhone.
+[* icon_note] Полоса будет растягиваться во много раз от ее первоначальной длины. Продолжайте вытягивать, снова захватывая полоску возле батареи, если необходимо, до тех пор, пока вся полоса не освободится.