crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0mashton27crwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 mashton27

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Remove the four 12mm Phillips #2 screws on the outer edge of the white case.
-[* icon_caution] Be careful! There are two small, fragile, plastic tabs at the bottom of the device keeping it together that are easily broken.
-[* black] Once you removed the screws, pick the device up so that the grey label on the bottom of the device is on the upper half facing towards you.
+[* icon_caution] Be careful! There are two small, easily-broken, plastic tabs at the bottom of the device keeping it together.
+[* black] Once you remove the screws, pick the device up so that the grey label on the bottom of the device faces toward you.
[* black] With your thumbs on either side of the grey label, slowly push with both thumbs until the case pops open.
[* icon_note] A small gap will open as the two tabs are released.
-[* icon_caution] The two halves are held together by the speaker wire, so do not pull them apart yet.
+[* icon_caution] Do not pull the two halves apart yet. They are held together by the speaker wire.