crwdns2933803:02crwdne2933803:0
crwdns2933797:0Sean Portunecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sean Portune
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Remove the four 12mm Phillips #2 screws on the outer edge of the white case. | |
| - | [* icon_caution] Be careful! There are two small, fragile, plastic tabs at the bottom of the device keeping it together that are subject to breakage. |
| - | [* black] Once you removed those screws, pick the device up such that the bottom grey label is on the upper half facing towards you. Slowly apply force to the bottom of the case. |
| + | [* icon_caution] Be careful! There are two small, fragile, plastic tabs at the bottom of the device keeping it together that are easily broken. |
| + | [* black] Once you removed the screws, pick the device up so that the grey label on the bottom of the device is on the upper half facing towards you. |
| + | [* black] With your thumbs on either side of the grey label, slowly push with both thumbs until the case pops open. |
| [* icon_note] A small gap will open as the two tabs are released. | |
| [* icon_caution] The two halves are held together by the speaker wire, so do not pull them apart yet. |