crwdns2933803:02crwdne2933803:0
crwdns2933797:0Vittorio Monteverdicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Vittorio Monteverdi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Remove the four 12mm PH2 Phillips screws on the outer edge of the white case. | |
| [* icon_caution] Be careful! There are two small, fragile, plastic tabs on the inside at the bottom of the device keeping it together that are subject to breakage. | |
| [* black] Once you removed those screws, pick the device up such that the bottom grey label is on the upper half facing towards you. Slowly apply force to the bottom of the case. | |
| - | [* icon_note] A small gap will open as the two tabs are released. |
| + | [* icon_note] A small gap will open as the two tabs are released |
| + | [* icon_note] The two halves are held together by the speaker wire, so do not pull them apart yet. |