crwdns2933803:04crwdne2933803:0
crwdns2933797:0Rachel Kangascrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rachel Kangas
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Using the T9 Torx head, loosen, but, ***do not remove*** the two screws at the bottom of the 1.2 inch gap going down the middle of the device. |
|---|---|
| - | [* icon_reminder] These screws are spring-loaded and can come out; be careful to not lose them. If you don't fully loosen the screw, then they can stay on the internal structure. |
| + | [* black] Remove the T8 Torx screwdriver head and replace it with the 60 mm extension; then, add the T9 Torx head. |
| + | [* red] Loosen, but ***do not remove*** the two screws at the bottom of the 1.2-inch wide gap in the middle of the internal structure. |
| + | [* icon_reminder] These screws are spring-loaded and will stay in the device, even when loosened; however, it is still possible for them to be fully removed. Be careful to ***only partially loosen*** them. |