crwdns2933803:04crwdne2933803:0
crwdns2933797:0Emanuele Artusicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Emanuele Artusi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Desolder the right driver |
|---|---|
| + | [* black] ***Desolder*** the two audio cables. |
| + | [* black] Put a few drops of ***flux*** over the tin of each solder. |
| + | [* black] Melt the tin with the ***soldering iron tip*** set at 320-350 degrees Celsius. |
| + | [* icon_note] ''The tin should melt easily, freeing the cable.'' |
| + | [* icon_caution] Do not leave the tip of the soldering iron for more than 4-5 seconds continuously over the pad and do not raise the temperature too high, you may ruin the circuit board. |
| + | [* black] ***Clean*** the pitches. |
| + | [* black] Pass with the ***desoldering braid*** over the remaining tin, resting the soldering iron tip on top. |
| + | [* icon_note] ''You can add a little more flux or use a tin remover pump.'' |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0