crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Teagan Dommcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Teagan Domm

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Squeeze the rocket blower to blow off any excess foam. Repeat as many times as necessary until the debris has been removed.
-[* icon_note] Remember to do each section of your camera you are replacing. This includes the crevices on the top and bottom of the inside of the camera, both sides of the door hinge, the clasp is located on the opposite end of the door, and the mirror bumper.
+[* black] Squeeze the rocket blower to blow off the excess foam. Target the crevices on the top and bottom of the camera, which are the same film compartment crevices you cleaned in step 6. Hold roughly an inch above the area.
+ [* black] Repeat as many times as necessary until the debris has been removed.