crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Teagan Dommcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Teagan Domm

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Measure the lengths of the cracks which held the foam that you have removed.
- [* black] Measure this same length onto your new foam.
- [* black] Cut the foam to a width of about 2-3 mm.
-[* icon_note] Going a little bit wider than 2-3 mm is ok because the foam will compress into crevices of the camera.
+[* black] Measure the length of the top and bottom crevices where the new light seals will be placed.
+ [* black] Measure this same length onto your new foam and cut it accordingly.
+ [* black] Trim the new foam to a width of about 2-3 mm.
+[* icon_note] The foam being slightly more than 2-3 mm wide is acceptable because it will compress into crevices of the camera.