crwdns2933803:04crwdne2933803:0
crwdns2933797:0Mollane Greedcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mollane Greed
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Reassembly | |
| - | [* black] Reassembly is simply a revers of the initial teardown process. |
| - | [* black] ***Speaker***: Inset it back into the hole with the two connection pads on the outside edge and snap the metal clip back into place. |
| - | [* black] ***Ribbon Cables***: Aligning the connectors can be a little tricky, I found it easiest to gently flex the connectors away from the battery and adjust the angle of the connectors. (See first image) |
| + | [* black] ***Speaker***: Insert it back into the hole with the two connection pads on the outside edge and snap the metal clip back into place. |
| + | [* black] ***Ribbon Cables***: Aligning the connectors can be a little tricky, I found it easiest to gently flex the connectors away from the battery and adjust the angle of the connectors. (See first image) |
| [* black] ***Gasket \ Seal***: This is a critical part of the reassembly as it will protect the internal components from water and moisture damage. | |
| [* black] Using a toothpick, apply a thin strip of the the RTV Silicone around the edge of the watch. | |
| [* black] Applying the silicone under the ribbon cables will be the trickiest part. I achieved this by saving this part for last and holding the bottom half of the watch above the other, ready to put it in place as soon as I was done. | |
| [* black] I placed a pee size glob of silicone onto a post-it note. Then by rolling the tip of the toothpick in it, I could get a small amount that was easy to apply with relative precision. | |
| [* black] With the seal in place the top and bottom should gently snap back together. When reinserting the screws gently tighten them in a cross pattern and do not over tighten. |