crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0Mattia polverosicrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mattia polverosi

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] now carefully lift the back panel and place a little of the epoxy onto the stick, carefully begin to place the epoxy onto the broken clip. in this case the clip was fully broken where the attachment points are located therefore I used the epoxy to create new attachment point on the remaining clip
-[* icon_caution] remember to always be careful to not get any epoxy on your hands
+[* black] Carefully apply epoxy to the broken clip. In this example, the clip was completely broken at the attachment point, so epoxy was used to build a new support on what remained.
+[* icon_caution] Avoid excess epoxy buildup and direct contact with your hands.