crwdns2933803:01crwdne2933803:0
crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Use a Phillips #1 screwdriver to remove the two 4.8 mm screws holding the brush roll motor. | |
| [* black] Remove the wires attached to the clip by pulling them away gently. | |
| + | [* icon_note] For helpful tips on removing the cables from the board, take a look at the [guide|25629|Recognizing and Disconnecting Cable Connectors guide.|new_window=true] |
| [* black] Pull the brush roll motor up to remove it. |