crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the 5 13.9 mm screws that hold the body of the vacuum together using a TR8 sized screwdriver.
-[* icon_note] These 13.9 mm screws are in deep recesses and the TR8 screwdriver will need an extension or a narrow shaft to reach them.
-[* orange] Remove the 2 9.3 mm screws holding the body of the vacuum together using a TR15 sized screwdriver.
-[* black] Pull the vacuum body apart by placing one hand on the bottom side of the vacuum and pulling with the other hand in the brush roll recess as shown.
+[* red] Use a TR8 Torx Security screwdriver to remove the five 13.9 mm screws from the bottom of the vacuum.
+ [* icon_note] These 13.9 mm screws are in deep recesses and the TR8 screwdriver will need an extension or a narrow shaft to reach them.
+[* orange] Remove the two 9.3 mm screws from the bottom of the vacuum near the dust bin cavity using a TR15 Torx Security screwdriver.
+[* black] To separate the vacuum body, place one hand on the bottom and pull with the other from the brush roll recess.