crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the 3 11.6 mm screws holding the suction motor using a PH1 sized screwdriver.
-[* black] Remove the wires clipped to the suction motor by pulling them away from the clip.
-[* black] Pull up on the suction motor to remove as shown.
+[* red] Remove the three 11.6 mm screws securing the suction motor using a Phillips #1 screwdriver.
+[* black] Disconnect the remaining wires connecting to the suction motor to the vacuum.
+[* black] Pull up on the suction motor to remove it.