crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0jack bouchercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jack boucher

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Once the back cover has been removed, locate the highlighted ribbon cable that connects the two halves of the device.
[* orange] Gently pry up the black plastic tab to slide out the ribbon cables
-[* black] Gently tug on the connection end (highlighted) of the ribbon cable until it slides out. The two halves of the camera will be separated as a result. Focus on the half that is shown in the third photo from this point onward.
-[* icon_note] Be gentle because this component is thin, but do not be afraid to damage the ribbon cable in this step. Add force progressively in small amounts.
+[* black] Gently tug on the connection end (highlighted) of the ribbon cable until it slides out. The two halves of the camera will be separated as a result. The side housing the LCD screen will be the main focus, shown in the third image.
+[* icon_note] Be gentle because this component is thin, but do not be afraid to damage the ribbon cable during removal. Add force progressively in small amounts.