crwdns2933803:09crwdne2933803:0
crwdns2933797:0Nemešcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nemeš
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Soldering in new rotary encoder |
|---|---|
| + | [* black] Rotary encoders side pins are bend so you will have to apply some pressure for it to snap into place. Please do not try to straighten the pins, they are bent for a reason! |
| + | [* black] Make sure that you position your new rotary encoder straight so you dont run into any problems later. |
| + | [* black] When adding solder to the pins please apply enough solder to cover the whole hole. Add flux for solder to stick only to designated spots. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0