crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Milton Soto Sanchezcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Milton Soto Sanchez

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Strip and tin the ends of the 5 wires on your replacement cable (if not already done).
[* black] Match wire colors to the board’s labeled pads (usually: VCC, D-, D+, GND, Shield).
[* black] Solder each wire carefully to its correct pad.
-[* black] Double-check your connections and make sure no solder bridges are present.
+[* black] Double-check your solder joints to make sure there are no bridges or cold connections.