crwdns2933803:07crwdne2933803:0
crwdns2933797:0iRobotcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 iRobot
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Continue the Warp |
|---|---|
| + | [* black] Make a small horizontal stitch at the bottom of the square, to the left of the initial stitch. |
| + | [* icon_note] The ideal gap between each vertical thread is the same as the width of the thread. |
| + | [* black] Wrap the thread around the second warp hook. |
| + | [* black] Continue this process until the warps cover the entire width of square or the thread begins to run out (stop when there is approximately 2" (~5cm) left and see Step 8). |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0