crwdns2933803:03crwdne2933803:0
crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] With a Phillips Head #0 screwdriver, unscrew the two speaker drivers attached with four, 7.5mm screws each. |
|---|---|
| - | [* black] Gently lift off speakers; the speakers may be slightly glued or stuck to the plastic plate so try not pull on the wiring attaching the components. |
| - | [* black] Unclip the two speaker wires from the circuit board by gently pulling upward. |
| - | [* icon_note] There may be a small piece of red tape that must be removed before the wire can be unclipped. |
| - | [* black] Remove speaker drivers with attached wires and set aside. |
| + | [* red] With a Phillips #0 screwdriver, remove the four 7.5 mm screws that secure the driver. |
| + | [* black] Repeat the previous bullet for the other driver. |
| + | [* black] Gently lift off the drivers; the speakers may be slightly glued or stuck to the plastic plate so try not pull on the wiring attaching the components. |
| + | [* black] Disconnect each of the the two driver connectors from the motherboard. |
| + | [* icon_note] There may be a small piece of sealant that must be removed before the connectors can be removed. |
| + | [* black] Remove the drivers. |