crwdns2933803:03crwdne2933803:0
crwdns2933797:0Jesus Lara Montielcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jesus Lara Montiel
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] With a Philips Head #0 screwdriver, unscrew the two speaker drivers attached with four, 7.5mm screws each |
|---|---|
| + | [* black] Gently lift off speakers; the speakers may be slightly glued or stuck to the plastic plate so try not pull on the wiring attaching the components |
| + | [* black] Unclip the two speaker wires from the circuit board by gently pulling upward; there may be a small piece of red tape that must be removed before the wire may be unclipped |
| + | [* black] Remove speaker drivers with attached wires and set aside |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0