crwdns2933803:08crwdne2933803:0
crwdns2933797:0P Badrickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 P Badrick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove Electronics Assembly from case |
|---|---|
| + | [* black] This is tricky and high rise of snapping plastic case. |
| + | [* black] There are two black plastic clips down sides just below the ring (roughly in line with button). Release these first with flat head screwdriver and there should be a little more flex in case. |
| + | [* black] Then you have to life motor out of case by bending the case out of shape at the top. Do one side at a time. Don't bend case more than is necessary. |
| + | [* black] Then assembly should lift up to like 30 degrees so you can slide out the connector at the bottom. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0