crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Jim Choucrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jim Chou

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Assemble connectors
[* black] Build Molex Micro-Fit 3.0 (MX3.0) male connector if needed
- [* black] Female pins are used in the male connectors. Orientation is important, they should click into place without excessive force, and should then not be able to be pulled out.
-[* black] JST XH 2.5 (2.54)mm plugs can be built, but can also be purchased pre-built in bulk, though on Amazon they are sold with matching male connectors.
+ [* black] Female pins are used in the male connectors. Orientation is important, they should click into place without excessive force, and should then be locked in place.
+[* black] JST XH 2.5 (2.54)mm plugs can be built, but can also be purchased pre-built in bulk, though on Amazon they seem to be sold only with matching male connectors. Aliexpress has just the correct pre-wired female connectors.
[* black] Check the color of the wiring before purchase - it's less confusing if the wire colors match that on the battery when plugged in.