crwdns2933803:03crwdne2933803:0
crwdns2933797:0Conner Spanglercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Conner Spangler
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Before we fully cut our wires, let's prep the new plug so that we save time and are able to feed the wire through the plug after we strip it. |
|---|---|
| + | [* black] Take your crosshead screwdriver, and locate the two screw on the top of the panel, which will usually be a different color and where the prongs exit from. |
| + | [* black] Unscrew these two screws and set them aside next to your plug. Your end result should look like Photo 2. Don't worry about any of the internal screws, those aren't needed yet. |
| + | [* icon_note] Don't lose the two screws you just set aside! Make sure they are far away from any corners or holes where they could fall into. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0