crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Conner Spanglercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Conner Spangler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] From here, we will be tightening the wires in order to make them thin enough to hook around the holding screws, so that the entire cable can be secured.
[* black] Take your pair of pliers, specifically the non cutting pliers and clamp down on the metal ends of the wires and gently twist them until they are connected together and much thinner as seen in Photo 2.
-[* red] From here, with our holding screws already primed, simply turn your pliers so that the wire makes a hook like shape as seen in Photo 3. From here simply tighten your screws again around each wire as indicated by the red circle.
-[* icon_note] If you remember, the direction the screw needs to be turned to tighten again is away from you, so hook the wire into the bottom of the screw so that the tips of the wire are pointing towards you. This will ensure that the wires are tightened onto the screw. See Photo 3 for the direction the wire should go.
-[* icon_note] For older wires like this, it is not necessary to connect a specific wire to ground or neutral, as in this case, older wires often did not have this, so the place in which each wire can be connected is entirely up to preference.
+[* red] With our holding screws already primed, simply turn your pliers so that the wire makes a hook like shape as seen in Photo 3. Simply tighten your screws again around each wire as indicated by the red circle.
+[* icon_note] From Step 6, the direction the screw needs to be turned to tighten again is away from you, so hook the wire into the bottom of the screw so that the tips of the wire are pointing towards you. See Photo 3 for the direction the wire should go.
+[* icon_note] For older wires like this, it is not necessary to connect a specific wire to ground or neutral, as in this case, older wires often did not have this, so they can be connected to either screw.