crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Conner Spanglercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Conner Spangler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_caution] Always be careful with knives. Never point them at you while cutting and always fold them when finished cutting.
-[* black] Comparing the length of your new plug, take your cutting knife, and mark a line on where the end of the plug lines up with the wire. This will be the reference point from which you cut the casing open.
-[* icon_note] The recommended length to cut in order to properly strip the wire is about an inch and a half, which can be referenced using the plug like I did.
+[* black] Comparing the length of your new plug, take your cutting knife, and mark a line on where the end of the plug lines up with the wire.
+[* icon_note] The recommended length to cut in order to properly strip the wire is about an inch and a half, and can be measured using the plug.