crwdns2933803:06crwdne2933803:0
crwdns2933797:0Damiancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Damian
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Insert replacement battery |
|---|---|
| + | [* black] Insert the battery connector onto the connector on the printed circuit board, and press down onto the board. |
| + | [* black] Bend the battery wires to arc the connection route better. |
| + | [* black] Optionally, sandwich the top of the connector plug with a thin piece of paper to act as more pressure onto the connector, in case if its port on the board is fragile or not connecting properly. |
| + | [* black] Now, test that the controller can be powered via USB for a couple minutes, then unplug and attempt to turn on the controller. |
| + | [* black] Once the connection is established, place thick double-sided adhesive onto the replacement battery opposite the rubberized part, and insert the battery into its chamber on the handle. |
| + | [* icon_caution] Carefully insert! There is a sharp corner on the handle, which could puncture the battery and cause a fire! |
| + | [* black] The battery wires should be nested on the side of the battery, not over, under, or in the way of the housing edges. |