crwdns2933803:04crwdne2933803:0
crwdns2933797:0Damiancrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Damian
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the adhesive, then the battery | |
| [* green] The battery is securely adhesed to the housing; use a hairdryer or hot air gun at moderate heat for 10 seconds to loosen the adhesive. | |
| [* yellow] Use a plastic guitar pick or spudger to separate the adhesive from the plastic housing. There should be less resistance; if it's still not budging, re-warm the area and try again. | |
| [* icon_caution] Do NOT use a sharp, metal object; this will risk puncturing the battery and causing a fire! | |
| [* icon_note] This adhesive is very tough, lasting several years. Be patient cutting through. | |
| - | [* red] Once the adhesive is freed, separate the controller apart more to handle the battery, and remove it from its housing. |
| + | [* red] Once the adhesive is freed, separate the controller apart more to handle the battery, and remove it from the main handle. |
| + | [* icon_note] The battery is plugged into the printed circuit board via an MX2 connector. |
| [* icon_caution] Be careful when removing! The inside chamber holding the battery has several sharp corners that could puncture the battery, and cause a fire! |