crwdns2933803:02crwdne2933803:0
crwdns2933797:0Ron Clobescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ron Clobes
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Cutting Strategy |
|---|---|
| + | [* black] The initial cuts were made along the red line and then on the seam on the back of the tank. IF I were to do this again, I would cut about 1/8" below the seam on the back of the tank. |
| + | [* black] The second photo is the tools I used. The dust mask is a MUST HAVE and the Dremel with the rotary saw got the most use. |
| + | [* black] Not shown is eye protection because I am wearing it. If you do this, plastic bits will be flying all over. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0