crwdns2933803:012crwdne2933803:0
crwdns2933797:0Steve Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Steve D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the cable retention from the rear housing |
|---|---|
| + | [* red] With the display removed from the rear body, remove the 4 screws on the cable retention mechanisms. The one on the flexible assembly is 2 pieces. The piece with the "ears" goes on the bottom with the ears out and up on reassembly. |
| + | [* icon_note] The rear cover passthrough plate has a rubber gasket that slots into a hole under the plate. Make sure both the plate and gasket are oriented and located correctly on reassembly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0