crwdns2933803:07crwdne2933803:0
crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* icon_caution] Do not overheat the terminals, as too much heat can damage the driver. | |
| [* black] Identify the soldering terminals inside the earpiece, then secure the wire in place by positioning the exposed end over the correct terminal. There are usually two per side: | |
| [* red] One for the signal wire (red or green). | |
| [* orange] One for the ground wire (bare copper or gold) | |
| [* black] With one hand, hold the soldering iron against the wire and terminal for 1–2 seconds to heat the connection. | |
| - | [* black] With your other hand, |
| + | [* black] With your other hand, feed solder to the joint so it melts and flows around the wire. |
| [* black] Remove the soldering iron and let the solder cool for a few seconds before moving the wire. | |
| [* black] Repeat for the second wire, ensuring both connections are secure and not touching each other before proceeding. |