crwdns2933803:02crwdne2933803:0
crwdns2933797:0Jacob Mehnertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jacob Mehnert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Printer Preperation Continued |
|---|---|
| + | [* light_blue] Set your Z-Axis to 100 mm or more by going to ***Control***, ***Move Axis*** then ***Move Z*** |
| + | [* icon_reminder] Allow your printer's heatbed to move |
| + | [* green] Once the heatbed has finished moving, turn your printer off using the power switch on the back of the printer. |
| + | [* yellow] Remove the power cord from the printer to prevent the printer from being powered on accedently. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0