crwdns2933803:04crwdne2933803:0
crwdns2933797:0Ben Schlichtercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Schlichter
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Examine the dryer timer and control panel |
|---|---|
| + | [* black] [youtubetimestamp|194.3|287.2]Remove the two screws on each side of the plastic console with a quarter inch hex or Phillips bit. |
| + | [* black] Remove the four screws holding the metal panel behind the console and lift the panel off. |
| + | [* black] Refer to the schematic stored here for terminal labels and timer contact points. |
| + | [* black] Use the multimeter on continuity or ohms to test the correct timer contacts while rotating the knob to a heat setting. |
| + | [* black] If no continuity is found on the proper contacts at any setting, replace the timer. |
| + | [* black] Inspect the dial and shaft for damage if the knob fails to rotate the timer internally. |