crwdns2933803:02crwdne2933803:0
crwdns2933797:0Ben Schlichtercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Schlichter
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Inspect power connections | |
| - | [* black] [youtubetimestamp|81 |
| - | [* black] Remove the lower panel screw with a quarter inch hex head driver and open the panel. |
| - | [* black] Look for any signs of damage or burnt wiring on the terminal block or cord. |
| - | [* black] Use a multimeter set to AC voltage to confirm 120 volts on each leg to neutral and about 208 to 240 volts across both hot legs. |
| - | [* black] Reset the breaker if voltage is incorrect, or replace the cord or consult an electrician if the outlet is faulty. |
| + | [* black] [youtubetimestamp|81|115]Move the dryer to access the rear panel where the power cord enters. |
| + | [* black] [youtubetimestamp|81|115]Remove the lower panel screw with a quarter inch hex head driver and open the panel. |
| + | [* black] [youtubetimestamp|81|115]Look for any signs of damage or burnt wiring on the terminal block or cord. |
| + | [* black] [youtubetimestamp|81|115]Use a multimeter set to AC voltage to confirm 120 volts on each leg to neutral and about 208 to 240 volts across both hot legs. |
| + | [* black] [youtubetimestamp|81|115]Reset the breaker by turning it off, then cycling on, if voltage is incorrect, or replace the cord or consult an electrician if the outlet is faulty. |