crwdns2933803:03crwdne2933803:0
crwdns2933797:0Massimocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Massimo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove upper Back-Cover |
|---|---|
| + | [* black] Get your iOpener/Heatgun and start by heating up the upper back cover. |
| + | [* black] Start heating around the edges and place your suction cup. Be careful about the display when heating. If heated enough, you should be able to insert a plectrum between the frame and the back glass. |
| + | [* black] Go around the frame and cut all the glue to remove the back cover. Make sure not to cut too deep into the glue to avoid damaging the display. |
| + | [* black] Lastly, you have to remove the plastic clip holding the secondary display's connector in place and unplug the cable using a plectrum. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0